Record Ride Data on the Display

Applies to: L1s and L1m

1. Start Recording

Manual start

On the ride screen, tap Record in the lower-left corner.

Automatic start

Turn on Auto Record under Settings → Trips.
If the bike is at Park mode, press and hold P button to exit.

Select an assist level and begin riding. Auto Record starts a recording once the applicable speed threshold is reached:
  • If Auto Pause is on, the threshold is the one set for Auto Pause.
  • If Auto Pause is off, the threshold is 0 km/h.
If you begin riding while an assist level is already selected, or stop and start again without returning to P, Auto Record does not start a new recording. A Start Recording? prompt appears instead.

Motion Detection

When Auto Record is off, turn on Motion Detection to receive a Start Recording? prompt as you begin riding.
  • If Auto Pause is on, the prompt appears when your speed exceeds its set threshold.
  • If Auto Pause is off, the prompt appears when the bike starts moving.
When the prompt appears:
  • Press the down button to start recording.
  • Press the up button to dismiss the prompt.
  • If you do nothing, the prompt closes after 10 seconds.
With Motion Detection on and Auto Record off, the prompt appears again the next time you ride if you start recording.
If you dismiss it, recording will not start automatically for the current ride or the next ride.

2. Pause Recording

Manual Pause

Just tap Pause in the lower-left corner to pause recording.

Auto Pause

Turn on Auto Pause and set a speed threshold to pause and resume recording automatically.
  • Below the threshold: recording pauses.
  • Above the threshold: recording resumes.
Notes
A manual pause takes priority. Resume a manually paused recording manually.
When Auto Pause is off, you can start recording manually at 0 km/h. If you stop, recording continues until you pause it manually.

3. Finish a Ride Recording

While recording is paused, tap the stop icon to finish the ride.
Rides shorter than 100 m are not saved. A message appears to let you know.
The same minimum distance applies if you power off the bike before ending the recording. In this case, the recording ends automatically and the ride data is calculated.

View the Ride Summary

After you finish a ride, a Ride Completed summary appears.
A route overview appears on the left. If location permission is off or no valid GPS data was recorded during the ride, a bike image appears instead.
This ride summary includes the following metrics for your current ride:
  • Distance
  • Timer
  • Carbon Saving
  • Average Cadence
  • Average Speed
  • Max Speed
Press the left button once to close the summary.
It also closes automatically when you begin riding above the Auto Pause threshold. If Auto Pause is off, it closes when you begin moving.