DJI OSMO Camera Pairing and Control

Note: This guide applies to L1s and L1m.

[Camera Pairing]

1. Turn on the camera

Press and hold the power button to turn on the camera.

Place it near the bike or mount it on the bike.

The display will auto-scan nearby Bluetooth devices.

2. Add camera on display

Go to Accessory Management (Helmet Icon) - [Extra]

Tap[+]，the icon for adding

Select [OSMO Camera]

3. Connect device

Tap [Connect] and select your camera from the scanned list.(If not found, tap "More" to view all available devices.)

4. Confirm pairing

Check the pairing code on your camera screen and tap [Accept] to confirm.

5. Check status

Once connected, the accessory card will show"Connected". Return to the Home screen — a DJI logo will appear on the right.

Note: A moon icon next to the DJI logo indicates the camera is in sleep mode (see image below).

[Camera Control]

Once paired, your handlebar buttons act as a remote control for the camera.

Check the table below to control your osmo camera through handle bar buttons.

Button	Button Illustration	Operation	Function	Description	Notes
Switch Button		Press and hold	Switch accessory	Cycles between connected cameras (e.g., Care Camera, action cam).	Requires at least two cameras connected
		Short press	Switch modes	Switches between photo and video mode	Requires a connected camera
			Remote wake-up	Wakes up your osmo camera	Make sure the remote wake-up feature is enabled through your osmo camera settings.
Function Button		Short press	Capture	Takes photo, starts/stops video recording	Requires a connected camera
		Press and hold	Power on/off	Powers on/off the connected osmo camera	/